Aquamist Manuals HFS-6 HFS-5 HFS-4 HFS-3 HFS-2 HFS-1 MF2 DDS3. As water injection is playing a more and more important role in power tuning, there is more need to have a “fail-safe” mechanism in place to detect the presence. Aquamist HFS3 – UPDATE installation completed w. picts . marketed the Aquamist 1s system with Volvo specific instructions and people were.

Author: Akinorr Kashakar
Country: Botswana
Language: English (Spanish)
Genre: Life
Published (Last): 11 October 2010
Pages: 50
PDF File Size: 7.58 Mb
ePub File Size: 2.62 Mb
ISBN: 189-8-87192-163-7
Downloads: 33840
Price: Free* [*Free Regsitration Required]
Uploader: Goltishura

I just completed the install of my Aquamist HFS-2 kit. I’ve seen enough chopped and modified harnesses for V6 Toyota Mr2’s.

What’s interesting is that the throttle response seems improved. Currently, aquamist is the only company that uses a PWM-valve delivery method. Originally Posted by jstro. How hard is the install? Ellicott City, MD iTrader: Originally Posted by marconi Did aquamiwt tapped directly in the injector wires?

Reviews There are no reviews yet. They modify the original HFS-3 firmware to work on N54 engine.

Parts Finder

I’m actually thinking of doing this. Yes, my password is: Like this meth kit. Find More Posts by Syndicategt. If I did the calc right that is ft lb of torque to go with his HP crank numbers.


Blazing bob is correct, since a progressive system injects at variable amounts, a larger jet is allowed. Never run low on coolant and backing off the power once the coolant temp gauge rises past the halfway mark i. E82 i Join Date: Originally Posted by garbergtsi. Proper solder and tape will be more than enough.

And unless you use shielded signal wires your signal tap wires can act like little antennas and add signal noise to the sensor output values.

Aquamist HFS-2 PWM meth injection system installed – review & pictures

I’m not trying to be a hardass here China and I try to rarely pull the rocket scientist card, lol. I do know for sure that the CANBUS lines are twisted pair wire sets which is a way of reducing the interference on digital data lines in noisy RF environments.

I was pretty surprised by the results! I will install in a few weeks, maybe even remember to take a picture or two and post back the results. When it is below 80, I can hit the normal 21 PSI. Perhaps this is why none of these “mods” are really scarya challengeor serious.

Find More Posts by Eliei. It can also work with boost if needed. I’ll post those up when I have the time. You can tell auqamist the wire is shielded by looking at the wiring diagram. The time now is There are DIYs on the forum for this.


Aquamist HFS4 Methanol Injection for BMW Direct Injection Engines

Today’s newer, knock-sensor-equipped vehicles are very good at staving off detonation by retarding ignition timing the moment detonation-also known as “knock”-is detected, but do so at the cost of severely decreased power output and fuel economy.

I have intercepted the wires from one of the car’s injectors, it’s not hard to do it. Other than that have fun with meth! Originally Posted by Eliei.

Stock S60r Totalled: I have done some good research on different products and have found mnual that are just as good if not better featured than aquamist. Yeah, not really a hard ass, but I wouldn’t use stop leak in anything either. It seems like on of those items that picks the name of the main stream product I like the controlled flow.