Contents. Issue Nov Applies to and controller software version PDS and INSTANT ACCURACY are trademarks of Eurotherm.” Issue The / is a versatile, high stability temperature or process controller, with self and adaptive tuning, in including: Modbus®, Eurotherm Bisync, and SPI. The 1/8 DIN unit is a controller with an extensive range of options. Either PID, ON/OFF or Motorized valve control can be configured, satisfying both.
|Published (Last):||15 January 2018|
|PDF File Size:||7.66 Mb|
|ePub File Size:||8.64 Mb|
|Price:||Free* [*Free Regsitration Required]|
The temperature or process controller with self and adaptive tuning, comes with a standard 8 segment setpoint programmer, with eurothfrm for one, four or twenty programs of 16 segments each. It has a modular hardware construction which accommodates a wide range of plug-in modules. Chris Mooney Official Rep. If they eurothwrm, I don’t know where it can be.
Series Temperature Control / Programming
Wdell, ramp-up, step down, repeat eurotheem. The mood in here. Eirotherm checked the SPrr parameter and found it to be set to ‘off’, so this cannot be the problem. As euortherm a question as this might be, but are you able to control the process without running a program? Charles Bureau June 26, The has a way to us the program 1 program ptyp 1 enable with 8 segment each program If you want to have many programs with 16 segment each then yo need to get the firmware upgrade to do that. Hello Chris, thank you for your prompt reply!
You have a choice to go with 1, 4 or 20 programs of 16 segments each, as it has a standard 8 segment set point programmer. Can you set a setpoint from the front panel and the controller will accurately control to that temperature?
Regards, Jon How does this make you feel? When ordering the controller mention that you want multiple programs with up to 16 segments each segment are the steps you program will do like: Overview Topics Products People Change log.
Eurotherm by Schneider Electric 2408 Temperature Controller Programmer
The is a versatile, high stability temperature or process controller. If this parameter is set to eurotyerm other than OFF, you will not be able to start your program.
How does this make you feel? Create a new topic About this Problem Please check this and let me know how it turns out. May be there are other possible reasons? Help get this topic noticed by sharing it on Twitter, Facebook, or email.
Thank you for your help! Jan Pischel April 17, Actually, I tried to start the program in manual control mode.
Community-powered support for Eurotherm. Jan Pischel June 27, Regards, Chris How does this make you feel? Jon Official Rep April 17,